U)pload: The "U" command is used to transfer files from your computer to
RBBS-PC.

You will be prompted for the name of the file you would like to upload
after you give the "U" command. You will then be asked to select a protocol
if you have not previously specified a default protocol (see the help for
the utility command F)ile transfer for a discussion of different
protocols).

The next series of commands will depend on the communications software that
you are using. Check the manual or document file that came with you
communications software for specific information.

UPLOAD GROUND RULES:  All callers are encouraged to upload files on this
system.  Any type of program or document is welcome, however, a few ground
rules are in order.  The files donated must contain only information that
can be shared with others.  Callers who upload files overtly take on the
sole  responsibility  that,  should these files be shared,  the  rights  of
others  will not be violated.  The SYSOP is not responsible for any of  the
data that is shared on this system.

TIPS:
1. You can stack the "U" command with the file name. That is, you can enter
"U;<filename> directly from the Files Menu. For example, you could type
"U;keydo.exe" to upload the "keydo.exe" file.

2. You can override the default protocol by including it at the end of the
command line.  For example, "U;LIST700.ARC;X" uploads LIST700.ARC using
Xmodem no matter what the default protocol is.
